Automet® FAB - Integrity Checking: Revision history

24 June 2026

• curprev 13:2613:26, 24 June 2026 Tristan talk contribs 1,193 bytes 0 No edit summary

27 March 2024

• curprev 12:2712:27, 27 March 2024 Tristan talk contribs 1,193 bytes −3 No edit summary

19 October 2023

• curprev 07:5707:57, 19 October 2023 Tristan talk contribs 1,196 bytes 0 No edit summary
• curprev 07:5707:57, 19 October 2023 Tristan talk contribs 1,196 bytes +1 No edit summary
• curprev 07:5707:57, 19 October 2023 Tristan talk contribs 1,195 bytes 0 No edit summary
• curprev 07:5707:57, 19 October 2023 Tristan talk contribs 1,195 bytes +14 No edit summary

3 October 2023

• curprev 13:4313:43, 3 October 2023 Tristan talk contribs 1,181 bytes +1,181 Created page with "The table below is the integrity report shown during data capture and can be reviewed later as the QA report. The integrity report errors show the difference between the data points captured, and the data on the design file in your chosen unit of measurement. These values show true differences for pipe OD / ID, flange OD and PCD, hub OD and support-base plate thickness. <gallery mode ="packed" widths= 300 px> File:KB 200.png|Example QA data during data capture </gallery..."