Automet® FAB - Integrity Checking

The table below is the integrity report shown during data capture which can be reviewed later as the QA report. The integrity report errors show the difference between the data points captured and the data in the design file in your chosen unit of measurement. These values show true differences for pipe OD/ID, flange OD and PCD, hub OD and support base-plate thickness.

• 
  Example QA data during data capture

The QA table in the image provides the following info:

Name	Numbered spool elements as identified in the design file
Description	Description of the spool element
Device	The declared device used for this measurement
Coverage	<90º = Rejected, 90º~135º = Poor, 135º~180º = OK, 180º~270º = Good, >270º = Very Good
Thickness	A check on the support shoe base plate against the design input
Plane	Maximum out of plane for all points
Pitch	Error between bolt-holes
Diameter Avg	Diameter error from design
Diameter Max	Diameter error from best-fit circle
PCD Avg	PCD error from design
PCD Max	PCD error from best-fit circle